Gui-Centric Task Template; Connecting To Dc Power - Cisco IR1101 Hardware Installation Manual

GUI-Centric Task Template

GUI-Centric Task Template
Connect a PC to the Console port either to configure the software by using the CLI or to troubleshoot problems
with the router. To connect a terminal or PC to the console port on the router and access the CLI, follow these
steps:
Step 1 Connect the mini-USB console cable to the console port on the router. The following figure shows the console location
on the router.
Figure 41: Console Connection
Step 2 Connect the opposite end of the mini-USB cable to the USB port on your laptop or PC.
Step 3
To communicate with the router, wait for your laptop or PC to discover the new device.
Step 4 If your laptop or PC warns you that you do not have the proper drivers to communicate with the router, you can obtain
them from your computers manufacturer, or go here:
https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx

Connecting to DC Power

Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than 60 VDC minimum, 5A maximum. Statement 1005
Warning Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV) requirements
in IEC 60950 based safety standards. Statement 1033
IR1101 Industrial Integrated Services Router Hardware Installation Guide
66
Connecting the Router