Cisco NCS 5000 Series Manual page 142

allow
formatted request and response streams. As one of the management services, XML should be capable of
applying MPP. To secure XML MPP data, XML keyword has been added to the command.
Task ID
Task ID
system
Examples
The following example shows how to configure all management protocols for all inband interfaces:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# inband
RP/0/RP0/CPU0:router(config-mpp-inband)# interface all
RP/0/RP0/CPU0:router(config-mpp-inband-all)# allow all
The following example shows how to configure MPP support on an XML peer in-band interface:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-ctrl-mpp)# inband interface all allow xml peer address ipv4
172.10.10.1
System Security Command Reference for Cisco NCS 5000 Series Routers
134
Management Plane Protection Commands
Operations
read, write