Setting The Dip Switch; Installing The Speed Dome - HIKVISION AP530HT Quick Start Manual

Follow the same instructions described above for the short-arm wall mounting. For outdoor
applications, please adopt the water-proof measures. The short-arm wall mount is not
recommended for outdoor applications.

1.3.3 Setting the DIP Switch

Set the address and baudrate for the speed dome. The default value of DIP switch is shown below:
 Address: 0
 Baudrate:2400
 Terminal Resistor: OFF
Please refer to the Section 1.2 DIP Switch Settings for DIP switch settings.

1.3.4 Installing the Speed Dome

The sketches of installing the speed dome are for reference only.
Steps:
1. Hang the safety rope to the speed dome and then hook to the mount as shown in Figure
1-16(left).
2. Route the cables of the speed dome through the wall mount.
3. Connect the corresponding video/power/RS-485 cables.
4. Install the speed dome to the mount, and secure the speed dome by rotating the speed dome
clockwise.
5. Fasten the two lock screws with the Allen wrench, as shown in Figure 1-16(right).
HD-TVI Speed Dome·Quick Start Guide
①
②
③
Figure 1-16 Install the Speed Dome
12