Install Strike; Install Latchbolt; Install Door Position Switch (Dps) - Assa Abloy Sargent IN100 Installation Instructions Manual

2 Install Strike

Install strike in the door frame (Fig. 2).

3 Install Latchbolt

1. Install latch with beveled bolt facing the strike.
2. Attach with two screws but DO NOT tighten completely at this time.
See section 8 - Secure Lock to the Door.
IMPORTANT: Latch bevel must match door bevel and
deadlocking latch must stop on strike when door is closed.

4 Install Door Position Switch (DPS)

1. Push wires through raceway toward lock prep.
2. Push DPS firmly into place by hand.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
3. Install magnet into door frame. Push firmly into place by hand.
See A7983.
4. To connect DPS to lock controller per diagram, refer to the wiring in
Step #10 (Page 15).
CAUTION: if DPS is not installed or is installed
improperly, door status monitoring features will
not function.
8 1-800-810-WIRE • www.sargentlock.com • A8189B
Strike
Deadlocking Latch
Fig. 3B
(Door Position Switch)
IN100 Cylindrical Lock
Centerline of
Latch Front and
(2) #8-32 x 3/4"
Latch Screws
DPS
Strike
Fig. 2
Inside of Door
Fig. 3A
Inside of Door
Fig. 4