Assa Abloy Interlock IEGL Instructions Manual

Electronic Gate Lock
IEGL
Description
The IEGL is a low voltage motor driven lock suited for securing vehicle and pedestrian gates. It is supplied with a matching strike plate and with a
rating of IP65, it can be installed externally or internally. A solid 18mm diameter stainless steel bolt pin ensures the highest strength while a bolt pin
stroke of 35mm offers flexible installation.
Integrated electronics provide complete control over the lock and offer an array of features;
• Multi–voltage input (12-24VDC)
• Multiple locking / unlocking attempts to correct misaligned doors
• Selectable automatic locking when the gate closes
• Fail Safe / Fail Secure user selection with a single switch
• Gate position monitoring
• Bolt locked and Bolt unlocked monitors
The lock incorporates a keyed manual override and wiring can be run securely through the locks base or externally through a 20mm wiring gland
(not supplied).
Included in the box are 4 x AA batteries. Because of the various fitting locations of the IEGL, no mounting bolts are supplied for the strike. The
mounting holes in the strike are 8.5mm slotted holes so accept M8 size bolts.
Pre - Installation Assessment
1. Mechanical:
Before the lock can be installed, consider its location and orientation. The IEGL can be mounted horizontally or downwards vertically but it
cannot be mounted vertically locking upwards. Mounting it in this way can allow water to penetrate that lock and will void the warranty.
Depending on the chosen mounting position, spacers or packers may need to be made and used.
When positioning the strike, it is important to achieve a reasonable level of alignment with the bolt pin as to ensure correct locking and
operation. The hole in the strike has a significantly larger diameter than that of the bolt pin, however installing the strike so the bolt pin goes into
the hole centrally is best as it will allow for movement of the door over time.
There are three magnets in the strike which offer the flexibility of mounting options and with the symmetrical design of the lock, the strike can
approach from either the right, left or bottom face of the lock.
Lock mounted to the ground.
Lock mounted to the gate frame vertically down.

Lock mounted to the gate frame horizontally.

Do not mount the lock vertically up.

