Table of Contents
Advertisement
STABILITY PADS
Caution: The stability pads are used to stabilize the printer after it has been
moved to its desired operating location. The stability pads must be set prior to
printer operation.
To stabilize the printer:
1.
Roll the printer to its desired operating location and verify that minimum space requirements have
been met.
2.
Thread the stability pad jackscrew downward until the stability pad makes contact with the floor.
3.
Turn the jackscrew an additional 1-2 turns downward and set the locknut firmly against the lower
frame member.
Note: Ideally, each caster wheel will remain in slight contact with the floor and
using minimal force, be able to be rotated.
4.
Repeat
step 2
GENERAL SAFETY PRACTICES
Abide by these general safety practices when working with this printer.
High Voltage: High voltage is present in the printer.
Warning: Only use an OSHA or CE approved step stool when accessing the area under
the top cover of the printer.
Warning: Always wear safety gloves and long sleeves when working in the oven, with the
head, or liquefier tips. These components are very hot.
and
step 3
to set all remaining stability pads.
28
Locknut
Jackscrew
Advertisement
Table of Contents
