Table of Contents
Advertisement
TIP WIPE ASSEMBLIES
Two tip wipe assemblies are located in the rear of the oven, one for model and one for support. Each assembly
consists of a flicker and a brush. The tip wipe assemblies keep the printer's tips and tip shields free of purged
material debris and material buildup.The tip wipe assemblies are mounted behind the purge chute and extend
through the purge chute via two slots cut into the chute's exterior.
After material is purged from a tip, the tip passes across the tip wipe assembly. The flicker cuts the purged
material from the end of the tip and knocks it into the purge chute. The brush cleans the tip and tip shield.
Purged material debris is guided down from the tip wipe assemblies to the bottom of the oven chamber via the
purge chute.
9
Tip Wipe Assembly
Model = left
Support = right
Advertisement
Table of Contents
