Table of Contents
Advertisement
6.
Open the Material Details page corresponding to the material bay for which you'd like to load
material by touching its Material Status Icon on the screen.
7.
Slowly turn the material spool and feed filament through the filament opening and into the drive
mechanism. Turn the spool and feed filament until the Load button refreshes and is displayed in
its selectable state.
•
Filament needs to be advanced approximately 2 inches (50.8 mm) to reach the filament present
switch.
When feeding filament, ensure that filament does not fall over the edge of the material spool to avoid
•
cross-winding and/or load errors.
•
The Material Status Icon will refresh and display in its solid gray unloaded state.
Filament
Opening
8.
Once filament is detected by the filament present switch press the Load button within the Material
Details page.
Note: Only one material can be loaded at a time.
9.
Press the Back button within the Material Details page to exit and return to the Materials page.
61
Material
Spool
Advertisement
Table of Contents
