Table of Contents
Advertisement
•
If you do not send files to the printer using GrabCAD Print and instead plug a USB flash drive into
one of the printer's USB ports, the Load File button will be visible within the Build page. You can use
this button to select a single job file you'd like to build directly from the flash drive.
Note: The Load File button within the Build page allows you to quickly select a
single file to build off of a USB flash drive. The selected file will automatically be
queued for building.
To load a file:
1.
Plug a USB flash drive into one of the available USB ports on the front of the printer.
2.
Press the Load File button within the Build page.
3.
The Load File page will be displayed; press the USB button within this page.
4.
The Load File page will display the contents of the USB flash drive. Locate the desired job and
select it by touching its row on the screen; doing so will open its Job Details page.
Note: If both USB ports contain a flash drive individual folder graphics will be
displayed on the screen representing each flash drive and its contents. Touching
the folder graphic on the screen will drill down into the folder and display its
contents. If a single flash drive is installed the job files located on the flash drive
will be displayed in individual rows.
40
Advertisement
Table of Contents
