Rear Panel - Yamaha NUAGE MASTER Ncs500-CT Operation Manual

Rear Panel

[AC IN]
1
For connection to the power cable.
[RS-232C]
2
For connection to an RS-232C cable. Connect this port to
the RS-232C port on the KVM switch. When you switch
between multiple DAW applications using the DAW
SELECT section with KVM switches connected and the
data to be sent to them configured in NUAGE Workgroup
Manager, the display content, active keyboard, and active
mouse will also change accordingly. For details, refer to
the PDF manual of NUAGE Workgroup Manager
(page 46).
[Power switch]
3
Turns the power on ( I ) and off (P).
NOTICE
Rapidly turning the unit on and off in succession can cause it
to malfunction. After turning the unit off, wait for at least 6
seconds before turning it on again.
[Network]
4
For connecting an Ethernet cable.
[TALKBACK OUT +4dBu]
5
This jack outputs the signal from the [TALKBACK
microphone] (page 25) on the top panel.
[TO PHONES L/R]
6
The signal input to [TO PHONES L/R] is output from
[PHONES A/B] (page 26) on the front panel.
1 2 3 4 5 6
NUAGE MASTER Operation Manual
Description of the Device
27