Yamaha NUAGE MASTER Ncs500-CT Operation Manual page 50

EDIT Section
[Display access] This button is used to switch
between the Edit and Mix windows.
It is lit when the Edit window is
active and is dim when the Mix
window is active.
[SNAP] Not applicable.
[AUTO SCROLL]
[AUTO SELECT]
[OBJECT SELECT] This button is used to switch the
Edit mode.
[RANGE SELECT] Not applicable.
[MOVE] This button is used to separate the
selection into a new region or
regions.
[CUT] This button is used to cut the
selection to the clipboard (same as
Cut from the Edit menu).
[COPY] This button is used to copy the
selection to the clipboard (same as
Copy from the Edit menu).
[PASTE] This button is used to paste from
the clipboard to the selection (same
as Paste from the Edit menu).
JOG WHEEL Section
[SCRUB] This button is used to select the
Scrub modes. This button is
mutually exclusive with the [PUNCH
IN], [PUNCH OUT], and [CYCLE]
buttons. Also, the cursor in the
window on the computer monitor
disappears.
[SHUTTLE] This button is used to select the
Shuttle modes. This button is
mutually exclusive with the [PUNCH
IN], [PUNCH OUT], and [CYCLE]
buttons. Also, the cursor in the
window on the computer monitor
disappears.
[SCROLL] Not applicable.
[SELECT]
[ZOOM] This button is used to select the
following cursor modes: Navigation,
Zoom, and Select.
[QUICK ZOOM] Same as above.
[FADE IN] Not applicable.
[FADE OUT]
[SPLIT]
[VOLUME]
[TRIM HEAD]
[TRIM TAIL]
[INC +]
[DEC -]
[Jog wheel] This wheel is used for shuttling and
scrubbing. It's also used for making
fine adjustments to the selected
region.
GENERAL CONTROL Section
[]/[]/[]/[] These buttons can be used to scroll
(up/left/down/right) the Mix and Edit windows, navigate
the Edit window, zoom waveforms,
and to make fine adjustments to the
selected region. Their exact
operation depends on the currently
selected cursor mode.
[ENTER] This button works the same as the
Enter key on your computer
keyboard. Pressing it opens the
New Memory Location dialog box.
While a dialog box is open,
pressing it performs the same
action as clicking the OK button.
[UNDO] This button is used to undo and
redo the last operation. Its indicator
lights up when the last operation
can be undone, and it flashes when
the last operation can be redone. A
redo is performed by pressing the
button with the [SHIFT] and [ALT]
buttons held down.
[SAVE] This button is used to save the
current session (same as Save
command in the File menu). Its
indicator lights up when there are
unsaved changes, and goes out
when there are no unsaved
changes. When pressed, the
indicator flashes and you can press
it again to go ahead and save the
current session, or press [ESC] to
cancel.
MODIFIER Section
[CTRL] This button is used in conjunction
with other buttons to modify function
operation. This corresponds to the
Control modifier key found on Mac
keyboards.
[SHIFT] This button is used in conjunction
with other buttons to modify function
operation. This corresponds to the
Shift modifier key found on Mac
keyboards.
[ALT] This button is used in conjunction
with other buttons to modify function
operation. This corresponds to the
Command modifier key found on
Mac keyboards.
NUAGE MASTER Operation Manual
Appendix
50