Yamaha NUAGE MASTER Ncs500-CT Operation Manual page 5
Hide thumbs
Also See for NUAGE MASTER Ncs500-CT:
- Supplementary manual (10 pages) ,
- Supplementary manual (10 pages) ,
- Supplementary manual (8 pages)
Table of Contents
Advertisement
CONTROL ROOM Section
Overview
This section is for operating the Control Room features. To
operate it, make sure that Control Room is turned on in
Nuendo and the channels you need have been created,
then configure the input/output routing for those channels.
The [DOWNMIX 1] – [DOWNMIX 4] buttons are for
selecting the Downmix presets 1 – 4. The [MONITOR A] –
[MONITOR D] buttons are for selecting Monitors A – D.
The [CONTROL ROOM LEVEL] knob is for adjusting the
Control Room level. However, when [PHONES] is on, you
can adjust the Phones level with this knob.
If you have configured multiple DAW software programs
and operate them by selecting the “DAW SELECT
Section”
(page
24), this section will always operate the
Control Room of DAW A. In other words, the Control Room
section is not affected by the DAW software selection.
Controls and Functions
1
5
8
2
6
9
7
)
3
4
Description of the Device
[Display access]
1
Calls up the “CONTROL ROOM Page”
(page
38) in the
[Multi function display]. When the CONTROL ROOM page
is shown, you can toggle among the tabs of the
CONTROL ROOM page.
[DOWNMIX 1] – [DOWNMIX 4]
2
Selects the Downmix presets.
Lamp
Description
Lit
Downmix preset has been selected.
Dim
Downmix preset has not been selected.
[MONITOR A] – [MONITOR D]
3
Selects the desired Monitor.
Lamp
Description
Lit
Monitor has been selected.
Dim
Monitor has not been selected.
Off
Monitor has not been configured yet.
[PHONES]
4
Assigns operation of the following controls to “Phones.”
• [CONTROL ROOM LEVEL knob]
• [EXT]
(page
7) in the MONITOR SOURCE Section
• [MIX]
(page
7) in the MONITOR SOURCE Section
• [CUE 1] – [CUE 4]
(page
7) in the MONITOR SOURCE
Section
Lamp
Description
Lit
The controls above are assigned to Phones.
Dim
The controls above are assigned to Control
Room.
Off
Phones settings have not been configured yet.
[CONTROL ROOM display]
5
Displays the assigned function and level, adjustable with
the [CONTROL ROOM LEVEL knob].
The level indication can be switched between the setting
value of Nuendo (dB) and SPL value. To change this,
select the MAIN page
(page
38) in the CONTROL ROOM
page shown on the [Multi function display]. You can set
the SPL value in the “Setup Page”
(page
29) shown on the
[Multi function display]. This value changes, maintaining
the difference with the value set in Nuendo.
Page 5
Advertisement
Chapters
Table of Contents
