Yamaha NUAGE MASTER Ncs500-CT Operation Manual page 6

[REF]
6
Sets the Control Room level to the Reference level. When
this is on (lit), the level is reset to the Reference level.
When you turn this is off (dim), the level is set back to the
previous setting. The button goes dim when you change
the level after turning this on.
When you press [REF] while holding down the appropriate
button(s) in the "MODIFIER Section"
function changes as follows.
Modifier button Function
[ALT] Resets the Reference level to the current
Control Room level setting.
[DIM]
7
Turns "DIM" on (lit) or off (dim). When this is on, the
Control Room level is lowered. When this is off, the
previous level is restored. You can set the desired "DIM"
level in Nuendo.
[SOLO CLEAR]
8
Turns off Solo or Listen for all channels. The button lights
while it is being held down.
Lamp Description
Flashing One or more channels in Mixer have Solo or
Listen turned on.
Off Solo and Listen are already off for all
channels.
[MUTE]
9
Turns Mute of the Control Room on (lit) and off (dim).
[CONTROL ROOM LEVEL knob]
)
Adjusts the Control Room level. However, when
[PHONES] is on, you can adjust the Phones level with this
knob. To adjust the level more finely (fine mode),
simultaneously hold down the knob and turn it.
(page 15), the
MONITOR SOURCE Section
Overview
This section lets you select the source of the Control
Room. To operate it, make sure that Control Room is
turned on in Nuendo and the channels you need have
been created, then configure the input/output routing for
those channels.
The [EXT], [MIX], [CUE 1] – [CUE 4] buttons are for
selecting the source of the Control Room. However, when
[PHONES] (page 5) in the CONTROL ROOM section is
on, you can select the source for Phones with these
buttons. The [EXT 1] – [EXT 6] buttons are for selecting
the "EXT" source, and [MIX 1] – [MIX 8] are for selecting
the "MIX" source.
If you have configured multiple DAW software programs
and operate them by selecting the "DAW SELECT
Section" (page 24), this section will always operate the
Control Room of DAW A. In other words, the Control Room
section is not affected by the DAW software selection.
NUAGE MASTER Operation Manual
Description of the Device
6