Yamaha NUAGE MASTER Ncs500-CT Operation Manual page 60

Control Room page
1
2
3
4
1 Turns the Main Monitor output on (lit) or off (unlit).
2 Displays the Monitor Level.
3 Turns the dimmer on (lit) or off (unlit).
4 Changes the Monitor Level value to the reference level value.
Holding this down for at least two seconds (until the indicator flashes) stores the current Monitor Level value as the
reference level.
5 Select the speakers which switches between SOLO and MUTE.
6 Turns the Headphone output on (lit) or off (unlit).
7 Displays the Monitor Level.
8 Touch MUTE to mute the speaker selected in (5). Touch SOLO to output audio from the speaker selected in (5).
9 Control the Headphone Monitor Level, DIM Level, Monitor Level, SPL, LFE Filter, LFE Trim Level, and Lip Sync Delay.
These controls are linked with MMP1 Editor controls and MMP1 Controller controls enclosed in the red frames.
MMP1 Editor — Main screen — Monitor
Control tab
5
6
7
8
9
MMP1 Editor — Sub screen — Monitor
section
Added functions in NUAGE V2.0 60