Yamaha NUAGE MASTER Ncs500-CT Operation Manual page 10

TRANSPORT Section
Overview
This section is for operating the transport functions.
Controls and Functions
3 4
1
2
9
8
$ % ^
[Display access]
1
Calls up the "TRANSPORT Page"
function display]. When the TRANSPORT Page is shown,
you can toggle among the tabs of the TRANSPORT Page.
[PRE ROLL]
2
Turns "Pre-roll" on (lit) and off (dim).
[POST ROLL]
3
Turns "Post-roll" on (lit) and off (dim).
[PUNCH IN]
4
Turns "Punch In" on (lit) and off (dim).
[PUNCH OUT]
5
Turns "Punch Out" on (lit) and off (dim).
[CYCLE]
6
Turns "Cycle" on (lit) and off (dim).
5 6 7
)
!
#
@
& *
(page 41) in the [Multi
[SYNC ONLINE]
7
Turns Synchronization on and off.
Lamp Description
Lit Synchronization is on.
Dim Synchronization is off.
Flash Synchronization is on; however, Nuendo has not
yet received external time code or clock.
[LEFT]
8
Moves the Project Cursor to the Left Locator position.
To set the current Project Cursor position to the Left
Locator position, press [LEFT] while the pop-up window
for the Set mode is shown after you've pressed [SET]
(page 20) in the NUMERIC PAD section.
To move the Left Locator position, simultaneously hold
down [LEFT] and turn the [Jog wheel]
JOG WHEEL section.
To set the selected area or range of the selected event to
the Right and Left Locators position, press [SET]
(page 20) in the NUMERIC PAD section to call up the pop-
up window for the Set mode in [Multi function display],
then simultaneously press [LEFT] and [RIGHT].
[RIGHT]
9
The same as [LEFT], except that the target is the Right
Locator.
[PREV EVENT]
)
Moves the Project Cursor to the start position of the event
under the Project Cursor, or the end position of the event
previous to the Project Cursor in the selected channels. To
move the Project Cursor continuously, hold down [PREV
EVENT].
[NEXT EVENT]
!
Moves The Project Cursor to the end position of the event
under the Project Cursor, or the start position of the event
next to The Project Cursor in the selected channels. To
move the Project Cursor continuously, hold down [NEXT
EVENT].
[MEM]
@
Whenever pressed (for 0.5 seconds or longer), this button
will store the current display condition of the Project
Window. The lamp will turn on when a display condition is
stored. Only one view can be memorized to this button.
You can recall the memorized view by pressing [ZAP].
NUAGE MASTER Operation Manual
Description of the Device
(page 13) in the
10