Installation; Connecting To The Pc Via Lan; Connecting The Unit To The Power Supply; Installing The Unit - Sirona CEREC MC XL Premium Package Operating Instructions Manual

5 Installation and startup
5.4 Commissioning
22
5.4.7

Installation

5.4.7.1

Connecting to the PC via LAN

An Ethernet connection is located to the rear of the unit, which can be
used to connect the PC to the milling and grinding unit. Use a network
cable to do this (LAN connection).
Using a network cable
Connect the PC to the LAN connection of the unit.
If problems arise when connecting via a network cable, please read the
separate instructions "Operating the MC XL via LAN".

Connecting the unit to the power supply

5.4.7.2
NOTICE
Grounded power outlet
The unit must be connected to a grounded power outlet.
➢ Connect the unit to the power supply using the supplied power cable.
5.4.7.3

Installing the unit

You must connect the unit to the PC before putting it into operation. This
is described in the section entitled "Connecting to the PC via LAN" [ → 22]
or "Connecting to the PC via WLAN (option)" [ → 27].
Operating Instructions CEREC MC XL Premium Package
D 3439.201.06.10.02 10.2017
Dentsply Sirona
63 98 536 D 3439