Connecting An Applicator; Connecting Power - Datamax A-Class A-4212 Operator's Manual

2.2.3 Connecting an Applicator

Setup the GPIO Port using the information in Appendix D and then connect the applicator
cable to port(s) on the Applicator Interface Card.
Failure to properly configure the GPIO Port(s) may result in damage to the
printer and / or the applicator.
If upgrading, a PE to A-Class GPIO conversion cable is available; see Appendix C.

2.2.4 Connecting Power

The power cord connects to the AC receptacle on back of the printer. Make the connection
and power-up the printer as follows:
1. Ensure that AC power to the host computer and applicator system are OFF.
2. Ensure that the printer's Power Switch is OFF.
A-Class 19