Fault Messages - Datamax I-class Maintenance Manual

3.3.2

Fault Messages

Fault Messages receive the highest display priority and, if multiples occur, messages will cycle.
Note: To return operation after a fault, correct the condition and then press FEED.

Displayed Message
ADC FAULT
CUTTER FAULT
DMA FAULT
Troubleshooting
Fault Messages
Description
An analog to digital Attempt to clear the fault by cycling the power OFF
converter failure and ON; if the fault does not clear, replace the Main
has occurred. Logic PCB (see Section 4.11).
1) Try cycling printer power OFF and ON.
2) Ensure the media being cut is within specification.
3) Ensure the cutter and cable are properly installed,
A blade-positioning
fault has occurred.
4) Clear any obstructions from the cutter.
5) The Cutter Motor or Motor Controller PCB may be
6) The Main Logic PCB may be defective; replace it
A Direct Memory
Cycle the power OFF and ON. If the fault does not
Access failure has
clear, replace the Main Logic PCB (see Section 4.11).
occurred.
Solution
WARNING! Turn OFF and unplug the printer
before examining the cutter.
and that the cutter cable is free of damage.
defective; replace the option.
(see Section 4.11).
3-9