Siemens SINUMERIK 840D sl Operating Manual page 222

Tool management
11.5 Tool list
Column heading
ST
D
Length
Radius
∅
Tip angle or
Pitch
N
M1 - M4
Further parameters
If you have created unique cutting edge numbers, they will be displayed in the first column.
Column heading
D no.
SN
EC
You use the configuration file to specify the selection of parameters in the list.
References
Information about the configuration and setup of the tool list can be found in the following
references:
222
Meaning
Replacement tool number (for replacement tool strategy)
Cutting edge number
Tool length
Geometry data, length
Tool radius
Tool diameter
Tip angle for Type 200 - twist drill and Type 220 - centering tool and Type
230 countersink
Pitch for Type 240 - tap
Number of teeth for Type 100 - milling tool, Type 110 - ball end mill for
cylindrical die-sinking cutter, Type 111 - ball end mill or tapered die-sinking
cutter, Type 120 - end mill, Type 121 - end mill with corner rounding, Type
130 - angle head cutter, Type 131 - angle head cutter with corner rounding,
Type 140 - facing tool, Type 150 - side mill, Type 155 - bevel cutter, Type
156 - bevel cutter with corner rounding and Type 157 - tapered die-sinking
cutter.
Direction of spindle rotation
Spindle is not switched on
CW spindle rotation
CCW spindle rotation
Coolant 1 and 2 (e.g. internal and external cooling) can be switched on and
switched off.
The coolant infeed at the machine does not necessarily have to be set-up.
Other tool-specific functions such as additional coolant infeed, monitoring
functions for speed, tool breakage, etc.
Meaning
Unique cutting edge number
Cutting edge number
Setting-up offsets
Display of the available setup offsets
Machine manufacturer
Please observe the information provided by the machine manufacturer.
Operating Manual, 05/2017, A5E40868517
Universal