Status Display - Siemens SINUMERIK 840D sl Operating Manual

Introduction
2.4 Operator interface
6 Display of active G functions, all G functions, auxiliary functions and input window for different functions (for example,
skip blocks, program control).
7 Horizontal softkey bar
8 Dialog line to provide additional user notes.
9 Operating window with program block display
10 Position display of the axes in the actual values window
11 Channel state and program control
12 Program name
Figure 2-3 User interface
2.4.2

Status display

The status display includes the most important information about the current machine status
and the status of the NCK. It also shows alarms as well as NC and PLC messages.
Depending on your operating area, the status display is made up of several lines:
● Large status display
The status display is made up of three lines in the "Machine" operating area.
● Small status display
In the "Parameter", "Program", "Program Manager", "Diagnosis" and "Start-up" operating
areas, the status display consists of the first line from the large display.
Status display of "Machine" operating area
First line
Ctrl-Energy - Power rating display
Display
The power rating display must be switched on in the status line.
Note
Information about configuration is available in the following reference:
System Manual "Ctrl-Energy", SINUMERIK 840D sl / 828D
32
Description
The machine is not productive.
The machine is productive and energy is being consumed.
The machine is feeding energy back into the grid.
Operating Manual, 05/2017, A5E40868517
Universal