T,F,S Window - Siemens SINUMERIK 840D sl Operating Manual

Introduction
2.4 Operator interface
Display
Collision monitoring
(only 840D sl)
Footer
See also
Zero offsets (Page 73)
2.4.4

T,F,S window

The most important data concerning the current tool, the feedrate (path feed or axis feed in
JOG) and the spindle is displayed in the T, F, S window.
In addition to the "T, F, S" window name, the following information is also displayed:
Display
BC (example)
Turning (example)
Tool data
Display
T
Tool name
Location
D
36
Meaning
Collision avoidance is activated for the JOG and MDA or
AUTOMATIC modes.
Note:
The $MN_JOG_MODE_MASK machine data can be set
to suppress the display of the symbol.
Please refer to the machine manufacturer's specifications.
Collision avoidance is deactivated for the JOG and MDA
or AUTOMATIC modes.
Display of active work offsets and transformations.
The T, F, S values are also displayed in the full-screen version.
Meaning
Name of the tool carrier
Name of the active kinematic transformation
Active tool carrier rotated in the plane
Active tool carrier swiveled in space
Meaning
Name of the current tool
Location number of the current tool
Cutting edge of the current tool
The tool is displayed with the associated tool type symbol corresponding to
the actual coordinate system in the selected cutting edge position.
If the tool is swiveled, then this is taken into account in the display of the
cutting edge position.
In DIN-ISO mode the H number is displayed instead of the cutting edge num‐
ber.
Operating Manual, 05/2017, A5E40868517
Universal