Installation
This section contains information for mounting, connecting, and wiring the XTP R HWP 201.
Topics in this section include:
•
•
•
•
•
•
Installation Overview
The XTP R HWP 201 can be installed into the provided mud ring or an optional UL Listed
metal electrical junction box.
ATTENTION:
1.
Installation Overview
Metal Junction Box or Mud Ring Installation
Rear and Side Panel Connectors
Mounting the XTP R HWP 201
Front Panel Connectors
Connection Details
•
Do not mount multiple devices adjacent to each other in the same metal junction
box. Add at least a one gang space between devices.
•
Ne procédez pas à une installation juxtaposée des appareils dans le même boîtier
de dérivation métallique. Veuillez laisser un espace d'un gang minimum entre
chaque appareil.
Prepare the mounting surface.
CAUTION: Risk of personal injury. Failure to check the items listed below may
result in personal injury.
ATTENTION : Risque de blessure. La non-vérification des éléments listés
ci-dessous peut provoquer des blessures.
ATTENTION:
•
Failure to check the items listed below may result in property damage.
•
La non-vérification des éléments listés ci-dessous peut provoquer des
dommages matériels.
Ensure there are no utility cables or pipes at the intended location that might be
•
damaged or cause injury when installing the device.
Check that the installation meets building, electrical, and safety codes.
•
Ensure there is sufficient space behind the device.
•
Choose a location that will allow cable runs without interference.
•
NOTES:
•
Cables may need to be installed in the wall or conduits before installation.
•
The mud ring does not require attachment to wall studs.
XTP R HWP 201 Wallplate Receiver • Installation
4