Setting The Cradle (Cu) Or Irda Communication Parameters; Setting The Communication Parameters; Setting The Communication Protocol Options; Setting The Transmission Speed - Denso BHT-1306BWB User Manual

 "1: COM1": Setting the Cradle (CU) or IrDA communication
parameters
1.
Select "1: COM1" at the SET COMMUNICATION menu and then press
the ENT key.
The SET SERIAL PORT <COM1> menu screen on the right is displayed.
2.
Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3]) to highlight
"1: PARAMETER", "2: PROTOCOL" or "3: DEVICE", and then press
the ENT key.
Press and hold the BS/C key

Setting the communication parameters

Select "1: PARAMETER" to display the screen on the right.
The highlighted setting is the current setting.
"1: TRANSMIT SPEED": Setting the transmission speed
To change the setting, highlight the transmission speed with the cursor
keys ([◄] [►]) and press the ENT key.
Press and hold the BS/C key to return to the SET SERIAL PORT <COM1>
menu.

Setting the communication protocol options

Select "2: PROTOCOL" to display the screen on the right.
The highlighted setting is the current setting.
"1: SERIAL No.":
Selects whether or not to add serial numbers to the data blocks.
"2: H.PARITY":
Selects whether or not to add a horizontal parity.
"3: LINKUP TIME":
Selects the timeout length (in seconds) to be applied when a link is
established.
"4: FIELD SPACE":
Specifies handling of the trailing spaces at the end of the field.
Select "Ignore" to trim the trailing spaces or "Data" to retain them as data.
To make changes, use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4]) to highlight the item to
be set, highlight the setting value using the cursor keys ([◄] [►]), and then press the ENT key.
Press and hold the BS/C key to return to the SET SERIAL PORT <COM1> menu.
Selecting the BHT-Ir or YMODEM protocol ignores the serial number and horizontal parity
- Point -
settings.
to return to the SET COMMUNICATION menu.
Barcode Handy Terminal
SET SERIAL PORT
< COM1 >
1：PARAMETER
2：PROTOCOL
3：DEVICE
SET PARAMETER
< COM1 >
1：TRANSMIT SPEED：
9600
38400
115200
SET PROTOCOL
< COM1 >
1：SERIAL No.
2：H.PARITY
3：LINKUP TIME ：
None 30
4：FIELD SPACE ：
Ignore
19200
57600
460800
：ON OFF
：ON OFF
60 90 120
Data
101