Waste - Canon imagePRESS C7010VPS Operating Information Manual

Removing the punch waste
Removing the punch waste
Introduction
This section describes how to remove the punch waste
#
IMPORTANT
Take care when handling the optional equipment that is attached to the machine.
When an optional unit's cover is opened to replace a staple cartridge, discard punch
waste, or clear paper or staple jams, prints may still be output if other optional units
are operating normally, and are not involved in the paper or staple jam removal pro-
cedure
#
NOTE
This procedure is necessary only if the optional Puncher Unit-BC1/BD1 is attached
to the optional Finisher-AJ1 or Saddle Finisher-AJ2.
Removing the punch waste
Open the front cover of the finisher.
1.
Pull out the punch waste tray.
2.
280 Chapter 9 - Paper, toner, and staples