Method - Canon imagePRESS C7010VPS Operating Information Manual

Change the finishing method
Change the finishing method
Introduction
The required finishing method is usually set in the printer driver. However, you can
change the finishing method on the operator panel.
Depending on the configuration of your system you can change the following finishing
methods, for example.
Number of staples.
Number of punch holes.
The location of the staples or punch holes.
How to change the finishing method
Touch 'Jobs' -> 'Waiting jobs'.
1.
Touch the job you want to change.
2.
#
NOTE
You can only change the settings of the active print job
printer (press the 'Stop' button 2x).
Touch 'Properties' - or touch the job 2x to open the 'Properties' window.
3.
Touch the 'Binding' button.
4.
Make the required changes.
5.
Press 'OK'.
6.
Press 'OK'.
7.
166 Chapter 6 - Print jobs
after you stopped the