4.4 Handling oil and water
4.5 Cable stress
Make sure there are no bends or tension on the power lines.
Be especially careful to signal line wiring to avoid stress because the diameter of the core wires
is only 0.2 to 0.3mm (0.0079 to 0.012 in).
Install a protective cover over the servomotor if it is used in
a location subject to water or oil mist.
Also use a servomotor with an oil seal to seal the through shaft
section.
15
Need help?
Do you have a question about the YPV-040 and is the answer not in the manual?