Working Examples On Untagged Vlan Using Web-Based Interface - Compex SGX3226 User Manual

Chapter 10 Application on Virtual LAN
10.2

Working Examples on Untagged VLAN using Web-based Interface

This section gives you a better understanding on how an Untagged Virtual LAN is being set up
using the Web-based Interface. You may follow the procedures stated below:
10.2.1 Hardware Setup for Networking
There are two VLANs, namely VLAN A and VLAN B in this network.
VLAN A
For Switch 1,
Connect Server 1, Control Unit and Workstation 1 to Port 1, 2 and 3 respectively.
For Switch 2,
Connect Workstation 4 and 5 to Port 7 and 8 respectively.
VLAN B
For Switch 1,
Connect Workstation 2 and 3 to Port 16 and 18 respectively.
For Switch 2,
Connect Server 2 and Workstation 6 to Port 24 and 19 respectively.
Notice that separate links are required between switches to join the two VLANs. You
need to connect ONE link first in order to prevent any looping, which might caused
malfunction to the entire network.
Make a link for Port 25 of both Switch 1 and 2. After finished all switches
configuration, connect one end of the network cable to Port 26 of Switch 1, and another
end to Port 26 of Switch 2.
NOTE
Please make sure that the port of Control Unit must be set within the same
Virtual LAN in the Web-based Management as the other ports in Switch 1
(VLAN A - Port 1 to 12), so that it can manipulate both the configuration of
the switches.
82