9.4.
How to set up priority port
You can easily set up the priority of the ports in Compex SAS2224 using the power
buttons.
3. Press the Mode button several times until the Priority LED lights up. You will notice
that individual LED will flash in sequence for a few seconds, starting from Port #1 to
Port #24. If the port LED is lighted up, it indicates that the port has already set its
priority, and nothing needs to be done. Otherwise, please proceed with the following
procedures.
4. Press Set button once when the desired port is flashing. The selected port LED will
light up and this shows that the port has been selected for priority setting.
5. To save your configuration, press Set button and hold it down for about 3 seconds
until the remaining LEDs flash thrice.
9.5.
How to set up VLAN
You can set up to four VLANs on Compex SAS2224.
VLAN 1
1. Press the Mode button several times until the VLAN1 LED lights up. You will notice
that all LEDs will light up all at the same time. Subsequently, each individual LED
will flash in sequence for a few seconds, starting from Port #1 to Port #24. If the port
LED is lighted up, it indicates that the port has already set in VLAN 1. Otherwise,
please proceed with the following procedures.
2. Press Set button once when the desired port is flashing. The selected port LED will
not light up for VLAN 1. This shows that the port has been de-selected from VLAN 1.
3. To save your configuration, press Set button and hold it down for about 3 seconds
until the remaining LEDs flash thrice.
12
24-port 10/100Mbps Fast Ethernet Switch
with Power Buttons
SAS2224
English