Table of Contents
Advertisement
program with "Direct to COMx" and date rate is 19200, 8-bit data bit,
no parity and 1 stop bit.
b)
Connect the PC free COM port to SGX3224 RS232 connector at the
back of the case with the null modem cable provided.
c)
Turn on SGX3224 and you will see message "System Ready" after a
short while (around 15 to 20 seconds).
d)
Press "Enter" key on the PC and you will see message "Access
granted" message. If you have used the Command Line Interface or
Web Browser Interface before and you have set the SGX3224 with
login password, there will be a login prompt asking for password after
you press "Enter" key. Just key in the password and "Access granted"
message will appear.
e)
Type "set ip address xxx.xxx.xxx.xxx" where x is desired IP address.
If you are not sure which IP address you should assign to SGX3224,
please consult your network administrator.
f)
Type "set subnet mask yyy.yyy.yyy.yyy" where y is the desired subnet
mask of the IP address.
g)
Type "set default gateway zzz.zzz.zzz.zzz where z is the default
gateway address.
Now the SGX3224 is ready to be browsed by the PC Web browse program.
Login to Web Browser Interface
1.
Connect the PC and the SGX3224 into the same network; the easiest way is
connecting your PC to any port of the SGX3224 directly through a UTP
cable (Cat 5 for 100Base-TX and Cat 3, 4 or 5 for 10Base-T connection).
2.
Power on the SGX3224 and wait for around 20 seconds.
3.
Open your browser program (IE4 or Netscape 4). Browse the IP address of
the SGX3224 (default IP is 192.168.168.99 or the IP set up in previous
procedure). You will see the following screen comes out on the Web
browser program:
10
Compex 24 - Port All 10/100 Management Switch
(SGX3224, SGX3224 PLUS)
English
Advertisement
Table of Contents
