Wan Config - Compex SGX3226 User Manual

Managed switch series 24+2 gigabit snmp switch with integrated router

Hide thumbs Also See for SGX3226:

Table of Contents

Chapter 5

Using Menu Tools

5.1.5

WAN Config

Compex SGX3226 is pre-configured as disabled. It can support Static IP, Dynamic IP

and also PPP Over Ethernet.

If you have chosen self-installation when you register for the broadband service, you

should first test the ADSL modem together with the logon account with your PC or

notebook. Make sure that it can connect successfully before attempting to run it with

CompexSGX3226. For simplicity and the purpose of illustrations, it is assumed that

LAN uses the IP address 192.168.100.xxx and Compex SGX3226 is using the same

settings as defaults.

However, if you have assigned a different IP address for Compex SGX3226, then use

the new settings in the setup procedures.

Figure 5.1-8

Default setting of Compex SGX3226 for WAN Setup

1. Select a WAN port and then a WAN Type. Any one of the 4 WAN Types are

eligible to configure, depends on which Internet Service Provider you subscribed.

2. Click "Save" button to update configuration.

Details on various broadband Internet services can be seen on "Configuring Your

Wide Area Network" on Page 44.

Table of Contents