Chapter 3 Hardware Installation - Compex SGX3226 User Manual

Chapter 3 Hardware Installation
Chapter 3 Hardware Installation
This chapter gives an in-sight on the hardware installation aspect from installing the physical cables to
resetting the device.
3.1 Physical Setup for Compex SGX3226
Compex SGX3226 is ideally suitable for office environment usage, which can be either installed
on a flat surface (desktop) or mounted on a 19-inch rack. The following steps illustrate how a
proper installation has to be done.
3.1.1 Desktop Installation
1. Unpack Compex SGX3226.
2. Remove the backing strip from the 4 rubber feet and attach to the underside of the
switch chassis firmly.
3. Place it with a power outlet located nearby. Be sure to set the device with sufficient
space for heat ventilation.
4. The surface to place Compex SGX3226 should be clean, smooth, level and sturdy.
5. Ensure there is enough space around the unit to allow attachment of network cables.
6. Connect the power cord to the power socket on the rear panel of Compex
SGX3226.
3.1.2 Rack-Mounted Installation
1. Position one bracket to align with the holes on one side of Compex SGX3226 and
secure it with the smaller bracket screws (1/8-inch diameter). Then attach the other
bracket to another side of it.
2. After attaching both mounting brackets, position the device in the rack by lining up
the holes in the brackets with the appropriate holes on the rack. Secure it to the rack
using the rack-mounting screws (5/16 inches diameters) with a screwdriver.
3. Connect the power cord to the power socket on the rear panel of Compex
SGX3226.
15