Table of Contents
Advertisement
Chapter 4
Software Installation
System Commands
sys reset system
sys reset config
sys save config
logout--Exit Management Commands
Logout
port—Port Management Commands
port show
port set enable <port
number>
[-h|-f] [-10|-100|-1000] [-A]
port set disable
<port number>
port set flw <port number>
<on|off>
port set bck <port number>
<on|off>
port set pri <port number>
<-p priority>
port set vid <port number>
<-v vid>
vlan--Vlan Management Commands
vlan show
vlan build <vid> <-u untags>
<-t tags> <-p priority>
vlan delete <vid>
vlan set pri <vid>
<-p priority>
trunk--Trunk Management Commands
trunk show
trunk set <port1> [port2]
[port3] [port4]
stp--Stp Management Commands
stp [on|off]
snmp—SNMP Management Commands
snmp [on|off]
24
Descriptions
Reboot the device
Reset the configuration of the device
Save the configuration of the device
Log out of Web Interface
List out the configuration of every port
Set the configuration of the port, such as Half/Full duplex
mode; speed, etc. E.g.
port set enable 1 –A (where -h: half duplex; -f: full duplex
and -A: Enable Auto-Negotiation)
Disable the respective port, e.g.
port set disable 10
Set flow control of the port, e.g.
port set flw 10 on
Set back pressure of the port, e.g.
port set bck 11 on
Set the priority of the port, e.g.
port set pri 1 10 -p 6
Set the vlan ID
<port number>: 1 to 26
<vid>: 1 to 4095
e.g port set vid 11 -v 1
Show the vlan configuration
set the vlan, e.g.
vlan build 2 -u 14,15 –t 14,15 -p 3
Delete the vlan ID, e.g.
vlan delete 3
Set the priority of vlan ID, e.g.
vlan set pri 1 -p 2
Show the individual port trunking
Set port trunking, e.g.
trunk set 1 2 3 4
Activate/Deactivate the Spanning Tree Management
function
Activate/Deactivate the Simple Network Management
protocol function
Advertisement
Table of Contents
