Configuration Of Compex Sgx3226 Using Web-Based Interface - Compex SGX3226 User Manual

Chapter 4 Software Installation
4.4

Configuration of Compex SGX3226 using Web-based Interface

After setting up Compex SGX3226, install a browser on the PC or workstation. Make sure that
TCP/IP protocol is installed and configured. Configuration will be much simpler, if you decided
to obtain IP address dynamically and use the gateway default IP addresses. Compex SGX3226
comes with a built-in DHCP server that automatically assigns IP addresses, DNS and Gateway
information to the computers connected in the same network. It has been pre-configured with IP
address and Subnet Mask of 192.168.100.128 and 255.255.255.0 respectively.
An Internet browser would be used to configure Compex SGX3226. The most commonly used
browsers include Netscape Navigator, Netscape Communicator and Microsoft Internet Explorer
browsers as they support frames and Java. We recommend you to use the Netscape
Communicator V4.06 and higher, or Microsoft Internet Explorer 4.0 and higher.
Start by running your browser on a workstation connected onto the same network as Compex
SGX3226. Enter URL Address, http://192.168.100.128.
4.4.1 Login to Web Browser Interface
The following is a list of the various ways for different browsers in accessing a website.
Follow the instructions for the browser that you use.
In Netscape Navigator
1. Select the File menu, then select Open Location.
2. In the Open Location dialog box, enter the IP address of the Gateway. This address
is set at the factory to: http://192.168.100.128.
3. Click on the "Open" button.
In Netscape Communicator
1. Select the File menu, and then press Open Page.
2. In the Open Page dialog box, enter the IP address of the Gateway. This address is
set at the factory to: http://192.168.100.128.
3. Make sure the Navigator radio button is selected then click the "Open" button.
25