Code 39; C.2.5 Code 39 - Psion Teklogix 7535 G2 User Manual

Appendix C: Bar Code Settings
Decoded (Internal) Scanners

Code 39

Prefix [P], Suffix [S1] And Suffix [S2]
A prefix and/or one or two suffixes may be appended to scan data for use in data editing.
When you double-tap on these parameters, dialog boxes are displayed in which you can
enter a value from 0 to 255.
Delete Char Set ECIs
Setting this parameter to on enables the scanner to delete any escape sequences representing
Character Set ECIs (Extended Channel Interpretations [also known as GLIs]) from its buffer
before transmission.
When this parameter is enabled, the scanner transmits data from PDF417 and MicroPDF417
bar codes containing Character Set ECIs, even when the ECI Protocol is disabled.
ECI Decoder
Setting this parameter to on enables the scanner to interpret any Extended Channel Interpre-
tations (ECIs) supported by the scanner. This parameter has no effect on symbols that were
not encoded using ECIs.
If this parameter is set to off and a symbol that was encoded using an ECI escape is scanned,
the scanner transmits the ECI escape followed by the uninterpreted data.
C.2.5

Code 39

Enabled
Setting this parameter to on enables "Code 39".
Enable Trioptic Code 39
Note: "Trioptic Code 39" and "Full ASCII" should not be enabled simultaneously. The
scanner does not automatically discriminate between these two symbologies.
Trioptic Code 39 symbols always contain six characters. Setting this parameter to on allows
this type of symbology to be recognized.
Convert To Code 32
Note: "Code 39" must be enabled in order for this parameter to function.
Setting this parameter to on allows the scanner to convert the bar code from "Code 39" to
"Code 32".
C-12 Psion Teklogix 7535 G2 Hand-Held Computer User Manual