Bluetooth Peripherals - Psion Teklogix 7535 G2 User Manual

Chapter 6: Peripheral Devices & Accessories

Bluetooth Peripherals

The interfaces available on the PDM are as follows:
• AC/DC adaptor jack (15VDC @ 2.5A).
• Type A USB host port (for connection to USB devices such as a mouse, keyboard,
printer, etc.).
• Type B USB device port (for connection to a USB host such as a PC).
Note: For information about data transfer with the Windows XP operating system and
ActiveSync, and with the Vista operating system, refer to "Data Transfer Between
The 7535 G2 And A PC" on page 34.
• RS-232D DE9 serial port (for connection to a PC COM port or a serial device such as a
printer).
The standard Psion Teklogix PDM kit (P/N HU4001) includes the necessary AC/DC adap-
tor, line cord, USB cables and RS-232D 9-pin cable.
The PDM contains reverse polarity and over voltage protection. If the AC/DC adaptor jack
is wired backwards or exceeds 20VDC, the PDM shuts down to protect the 7535 G2, the
PDM and the power supply from damage. Psion Teklogix does not recommend substituting
the AC/DC adaptor provided with your PDM.
The power supplied by the PDM is sufficient to operate the 7535 G2 and fast charge its in-
ternal battery at the same time. The 7535 G2 can run from a PDM without a battery
installed.
Important: Please see "Warnings To Users" on page xxiii for AC/DC adaptor safety
6.10

Bluetooth Peripherals

It is possible to communicate with a variety of Bluetooth peripherals, including GSM/GPRS
handsets, scanners, printers, and so on. The range of the Bluetooth radio in the 7535 G2 is
limited to approximately 10 meters (32 ft.). The Bluetooth antenna is located behind the
scanner 'bulge' on the back of the hand-held.
Psion Teklogix provides built-in support for:
• Bluetooth equipped cell phone.
• Serial Port Profile (SPP).
• Dial-up Networking Profile (DUN).
• Object Push Profile (OPP).
192 Psion Teklogix 7535 G2 Hand-Held Computer User Manual
instructions.