Omron CP1L-EL20DR-D Operation Manual page 625

LCD Option Board Function
Example 2
1,2,3...
Display the value of PLC Setup on 080. Then change the value to 0195.
1. Switch to the Setup Mode.
2. Press the Down button to select PLC Setup.
3. Press the OK button to enter the PLC Setup menu.
4. Press the Down button to select PLC Setup.
5. Press the OK button to enter the PLC Setup Screen
a
The following table shows the setting items.
No.
b
c a Address of PLC Setup
b PLC mode (Read only)
d
Value of PLC Setup after change
c
(Read only when PLC mode is RUN or MON)
d Value of PLC Setup before change (Read only)
The first digit of PLC Setup address will be flashing. The range of the
address is 000 to 511.
6. Use the Up button to change the address to 080.
After the address is changed, the value of PLC Setup will be updated im-
mediately.
7. Use the Forward button to move the column cursor to the value of PLC
Setup.
Use the Up button to change the value to 0195.
Note Before changing the value of PLC Setup, make sure that the PLC
mode is PRG. If PLC is in RUN or MON mode, the value is unchange-
able.
Section 11-6
Description
591