How To Control The Unit; Dmx 512 Connections - ACME TB-1010QW II User Manual

seconds to exit the current mode.
SOFTWARE VERSION
To select , press the ENTER button to show SOFTWARE VERSION on the display and the display
will show the version of software of the unit . To go back to the functions without any changes press the
MENU button again. Press and hold the MENU button for about one second or wait for 7 seconds to exit
the current mode.

4. How to Control the Unit

4.1 DMX 512 Connections

The DMX512 is widely used in intelligent lighting control, with a maximum of 512 channels.
1. Connect the fixture together in a "daisy chain" by XLR plug cable from the output of the fixture to the
input of the next fixture. The cable cannot be branched or split to a "Y" cable. Inadequate or
damaged cables, soldered joints or corroded connectors can easily distort the signal and shut down
the system
2. The DMX output and input connectors are pass-through to maintain the DMX circuit when one of the
units' power is disconnected.
10A