ACME TB-1010QW II User Manual page 8

DMX 512 ADDRESS
To select , press the ENTER button to show DMX ADDRESS on the display. Use the DOWN/UP
buttons to adjust the address from 1 to 512. Once the address has been selected, press the ENTER button
to setup. To go back to the functions without any changes press the MENU button again. Press and hold
the MENU button for about one second or wait for 7 seconds to exit the menu mode.
CHANNEL MODE
To select , press the ENTER button to show CHANNEL MODE on the display. Use the DOWN/UP
button to select 4, 4D, 4C or 40 channel modes. Once the mode has been selected, press the ENTER
button to setup. To go back to the functions without any changes press the MENU button again. Press
and hold the MENU button for about one second or wait for 7 seconds to exit the menu mode.
SHOW MODE
To select , press the ENTER button to show SHOW MODE on the display. Use the DOWN/UP
buttons to select
the (fade time) will blink on the display, use the DOWN/UP button to adjust the fade time (0 ~
255); and press the ENTER button again, the
adjust the wait time (0 ~ 255). Press and hold the MENU button for about one second or wait for 7
seconds to exit the menu mode.
BLACKOUT MODE
To select , press the ENTER button to show BLACKOUT MODE on the display. Use the DOWN/UP
buttons to select
the ENTER button to setup. To go back to the functions without any changes press the MENU button
again. Press and hold the MENU button for about one second or wait for 7 seconds to exit the current
mode.
(show 1) or ...
(blackout) or
(show 16), and then press the ENTER button to confirm,
will blink to display, use the DOWN/UP button to
(normal) mode. Once the mode has been selected, press
7A