Table Of Error Codes - Brother KE-430HX Instruction Manual

10. TABLE OF ERROR CODES

10. TABLE OF ERROR CODES
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
If a malfunction should occur with the sewing machine, a buzzer will sound and an error code will appear in the touch panel.
Follow the remedy procedure to eliminate the cause of the problem.
Switch-related errors
Code
The stop switch was pressed.
E010
Turn off the stop switch to clear the error.
The stop switch was pressed.
E011 Press the reset key to clear the error.
You can press the change stitch count key [▼] to move the work clamp so that you can continue sewing.
The stop switch was pressed.
E012 Press the reset key to clear the error, and then depress the foot switch to the 2nd step to carry out home position
detection.
The stop switch is being pressed when the power was turned on, or there is a problem with the connection of the
E015 stop switch.
Turn off the power, and then check that connector P15 on the main P.C. board is properly connected.
Problem with the stop switch connection when the power was turned on.
E016
Turn off the power, and then check that connector P15 on the main P.C. board is properly connected.
The start switch was pressed without lowering the work clamp.
E020
Release the start switch to clear the error.
The start switch (2nd foot switch) is being pressed, or there is a problem with the connection of the start switch
E025 (foot switch).
Turn off the power and check the foot switch.
The work clamp switch (1st foot switch) is being pressed, or there is a problem with the connection of the work
E035 clamp switch (foot switch).
Turn off the power and check the foot switch.
Machine head tilting was detected after the power was turned on.
E050 Turn off the power, and then return the machine head to its original position.
Check that connector P9 on the main P.C. board is properly connected.
Machine head tilting was detected while the sewing machine was operating.
E051
Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.
Machine head tilting was detected when the power was turned on.
E055 Turn off the power, and then return the machine head to its original position.
Check that connector P9 on the main P.C. board is properly connected.
The operation panel key is being pressed or there is a problem with the switch.
E065
Turn off the power, and then check.
90
DANGER
Cause and remedy
KE-430HX/KE-430HS, BE-438HX/BE-438HS