Designing A Customized Test Protocol - Interacoustics Affinity 2.0 Additional Information

2.0
Affinity Additional Information
3.8.2

Designing a Customized Test Protocol

The following sections describe how to setup your own test protocol in the HIT440 setup. All setup options
for all tests will be described even though you most likely will only need a few. This section is therefore to be
seen as a work of reference where single functions can be looked up rather than a step-by-step guide where
all steps need to be explored.
1) Enter the REM440 setup by pressing Menu/Setup/HIT440 setup.
2) Press New.
3) A pop-up will ask whether the new test protocol should be based on a copy of the currently selected
test protocol. When asked by the message box:
Yes: The system will create a copy of the current test and allow you to add new tests, make
changes, and save it under a new name.
No: The Selected tests section will be blank and you can create a new test from scratch
.
2
Page 293