Combined Screen Setup - Interacoustics Affinity 2.0 Additional Information

2.0
Affinity Additional Information
2.6.3

Combined Screen Setup

REM440 can be setup for default curve comparisons. This is done in the Combined screen settings menu.
1) To enter the Combined screen settings menu, select your protocol in the Select protocol dropdown
list in the main setup.
2
2) Click on the Combined screen button.
This will prompt the combined screen setup below:
3
3) To create a default curve comparison view, click on Add new screen. A tab will then appear in the
upper part of the screen.
4) Use the arrows to move the measurements to be compared (listed to left) to the new screen. If
preferred you can add several new comparison screens.
5) When finished click OK to return to the main setup.
Note: Before closing the setup remember to tick the Display combined screen check box for the
combined screen settings to be active.
When a combined screen view is setup you can click on the Toggle between single and combined screen
button in the front screen to view the desired curves together:
If no combined screen view is setup Toggle between single and combined screen will show all measured
curves.
4
5
Page 231