The Rem 440 Menu Items - Interacoustics Affinity 2.0 Additional Information

2.0
Affinity Additional Information

2.8 The REM 440 Menu Items

The REM440 Menu gives you access to File, Edit, View, Mode, Setup, and Help.
1
2
3
4
5
6
1) Menu/File
 Menu/File/Print will prompt the system to print using the selected print template (see section 4.1)
 Menu/File/Print Preview prompts a print preview of the current protocol using the print template
which is linked to the current protocol. Note that you are prompted to select a template if the
protocol did not include a template (see how to create a print layout in section 0)
 Menu/File/Print Layout opens the print wizard window from where you can select or create a
template to print the current protocol (see section 4.1 for details regarding the Print Wizard).
2) Menu/Edit

Menu/Edit/Delete will prompt the system to delete the selected curve.

Menu/Edit/Delete all will prompt the system to delete all measured curves.
 Menu/Edit/Export will prompt the system to export the session as an XML formatted file.
 Menu/Edit/Session information will prompt a window where you can type in your own data
regarding the test situation. The text will be specific for each session.
3) Menu/View
 Menu/View/Combined screen will activate the combined screen view function (see section 0)
 Menu/View/Left ear will activate the left ear in the front screen.
 Menu/View/Right ear will activate the right ear in the front screen.
 Menu/View/Both Ears will activate both ears at the same time in the front screen (this can also be
obtained by right clicking on the ear icon)
 Menu/view/Save window position will save the current position of the REM440 window on the PC
screen so that it opens at this exact position every time. This is for example practical if you are
usually running and viewing other software modules (such as fitting software) at the same time.
Using this function for moving and/or resizing of the REM440 will only be necessary once. Note
that on-top mode is also available (see section 0)
4) Menu/Mode
 Menu/Mode/Single measurement will set the system to present the selected stimulus as a single
sweep.
 Menu/Mode/Continuous measurement will set the system to present the selected stimulus
continuously.
 Menu/Mode/Probe placement will activate the probe tube placement tool.
If uncertain about the placement of the probe tube the probe tube placement tool may be of
assistance. Pressing the button will prompt a 6000 Hz tone. When the column is as low as
possible, mark this position on the probe, add 10 mm and a correct probe placement (3-6 mm from
the ear drum) will be obtained (Sullivan 1988). Press the button again when finished.
Page 242