Rear/Reag Settings - Interacoustics Affinity 2.0 Additional Information

2.0
Affinity Additional Information
2.6.2.2

REAR/REAG Settings

1
1) Ensure that REAR/REAG is marked in the left hand s
appear in the Name of selected test section
Note the option to write a new name for the test in this section (e.g. "REAR/REAG 70 dB input")
2) Stimulus selection

Input Level: Set the input level using the slider.

Preconditioning: This is relevant when using broadband signals such as ICRA (see section 0
for details). Select a time using the slider.

Stimulus type: Select a stimulus using the dropdown list.

Smoothing Index: You have the option to smooth the measured curve using the slider (see
section 0 for details). The higher index number selected the more smoothing is applied.

Continuous: This check box allows you to make the measurement on going rather than a
single sweep. This may, however, also be done in the front screen using the continuous
button:
When continuous is ticked, the stimulus and recording will continue until you press the STOP
button. This can be practical either if you want to change the settings of the hearing aid and
observe the changes in hearing aid performance.

View as gain allows you to view the measurement as a gain curve by default. If you wish to
view it as response, ensure that the check box remains unticked (see section 0 for details
regarding Gain versus Response view).
2
4
5
ide of the screen. The name of the test will then
Page 218
3