The Speech Screen Elements - Interacoustics Affinity 2.0 Additional Information

2.0
Affinity Additional Information

1.3 The Speech Screen Elements

The following section describes the elements of the speech screen in addition to the tone screen:
Input levels sliders allow for adjusting the input level to 0 VU for the
selected input. This ensures that correct calibration is obtained for Mic1,
Mic2, CD1, and CD2.On the VU Meter the dial intensity is achieved when
the signal is at the 0 mark.
WR1, WR2 and WR3 (Word Recognition) allows selecting different speech
list setups as defined by the selected protocol. The labels of these lists
which go along with these buttons can also be customized in the protocol
setup. (See section 1.7.2.3).
The Output list for channel 1 provides the option to test through head
phones, bone conductor, free field speakers or insert phones. Note that the
system only shows the calibrated transducers.
The Input list for channel 1 provides the option to select white noise (WN),
speech noise (SN), microphone 1 or 2 (Mic1 and Mic2), CD1, CD2 and
wave file.
Note that the background shading of the speech Audiogram is according to
the side that is selected, red for right and blue for left.
Page 10