Table of Contents
Advertisement
"Measurement Record".
"General Setup" interface is shown in Fig 16.2.
"Buzzer": Switch on or off to open/close the alarm buzzer function. When the instrument
inspects power value beyond normal range, buzzer will automatically give an alarm while
this function is switched on.
"Unit": Switch to select "W" or "dBm".
"Auto Zero": This function provides an easy method of auto zero of power meter, which
can be used to rectify the instrument's power value under non-luminous state in daily
testing.
tie-in is completely airproof and no laser signal.
"Wavelength": Select to display one wavelength individually or three wavelengths
together.
Create or delete Threshold value in the "Threshold" interface is shown in Fig 16.3.
Click "setup"=> "Current Thre. Set" to select a certain threshold set.
Or select the ready threshold set on the left. Click a certain threshold set and then the
information will be shown on the right area.
Double-click the certain Threshold Set to modify Thres. Set as shown in Fig 16.4. Click OK
to save the setting.
Put protective cap on optical power testing output, and ensure that the
Fig 16.3 PON Power Meter – Threshold Interface
AD1000 User's Manual
- 88 -
Advertisement
Table of Contents
