Table 3-2: Operator-Supplied Tools
Level bar
Percussion drill
and drill heads
5mm L-shaped
Allen wrench
3.4 Software
As part of finishing the base station installation process, you will need a computer to log in
and verify that the base station status is reported as active by:
Using a local Ethernet connection to the base station to access the Web GUI client
•
application; or
•
Accessing the internet to reach the cloud-based OMC application.
3.5 Appearance
Looking at Figure 3-1, familiarize yourself with the various interfaces on the bottom of the base
station. The interfaces are described from left to right in Table 3-3.
Figure 3-1: Interfaces
Marking pen
Hammer
Cross screw driver
Torx screw-
T7 screwdriver
driver
Knife
Pliers
Cable vice (crimper) Tape measure
Cable Stripper
head
14
Wrench