Check Enb Status In Software; Enb Gui; Figure 3-15: Active Status (Enb Gui) - Baicells Nova-233 G2 Installation Installation

j. The Tracking Area Code (TAC) field is used to identify a cluster of cell sites.
Enter a value between 0 - 65535 for each unique TAC ID in your network.
k. The RF Status field is used to enable or disable RF transmissions. In closed
environments, such as when "bench testing" the eNB, always disable the RF
for personal safety.
l. The Power Modify field allows you to set the output power on each antenna
port. This parameter is typically left with the default values, though you may
lower it when testing the eNB on the ground. Every 3 dB doubles the power.
The eNB output power must stay within regulatory guidelines.
NOTE: Any changes to Quick Settings requires a reboot of the eNB.
8. Reboot the eNB for the settings to take effect. The Reboot function is the last menu
in the GUI.

3.6 Check eNB Status in Software

Once the eNB is powered up, check that the eNB status is reported as active in software using
either the eNB GUI or the OMC. Each method is described below.

3.6.1 eNB GUI

Go to BTS Info > Basic Info and check the Cell Status field, as shown in Figure 3–15. If the status
is not reported as active, contact
Figure 3–15: Active Status (eNB GUI)
Baicells support.
23