Table of Contents
Advertisement
Installation Preparation
3
3.1 Personnel
Installing the base station on a tower, building, or other structure may require at least two
people or a tower crew. Installation personnel should be familiar with and follow standard
safety precautions concerning height, electricity, and other regulations. BaiCells recommends
that installation personnel review this entire installation guide prior to beginning the
installation.
3.2 Operator Network Design Plan
Installers should refer to the operator's network design plan for information about specific
network components, IP addressing, radio frequency (RF) coverage goals for the specific cell
site, and initial configuration settings.
Each cell site may be unique in terms of the type and number of components to install, the
coverage area, the user requirements, and so forth. Clearly identify the structure on which the
base station equipment will be installed, the intended height where the antenna and base
station will be attached, the degree of antenna down tilt, and other necessary specifications
that may impact the success of the installation.
3.3 Materials and Tools
Tables 3-1 and 3-2 describe the materials and tools required during the installation procedure.
Table 3-1: Materials (may be purchased through BaiCells or an authorized supplier)
Item
Power Cable
RF Cable
Ethernet Cable
RF Antenna*
Ground Wire
*Note: BaiCells does not manufacture antenna components; please refer to the list
of distributors on the BaiCells website: https://na.baicells.com/where-to-buy/.
Make sure to match the frequency range of the antenna with the base station, and
consult the
regulatory rules
Quantity Description
1
Gauge: Less than AWG16 (e.g., AWG14)
Length: Shorter than 1150 feet (350.5 meters)
2
50ohm feeder
1
CAT5e or CAT6
Shorter than 330 feet (100.6 meters)
1
Omnidirectional or Directional
Maximum 1 antenna per base station
1
16mm² diameter yellow-green wire
concerning output power specific to your location.
13
Advertisement
Table of Contents
