Configuring The Device As Client Bridge; Using Client Bridge Mode; Repeater Mode - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide

Configuring the Device as Client Bridge

System > Operation Mode
1
Log into your access point management page (refer to
on page 10).
2
Click System > Operation Mode.
3 In Operation Mode section, select Client Bridge.
Í Note: In the following example the Client Bridge mode is selected for 2.4GHz wireless
profile.
4
To save changes, click Apply.
Í Note: To discard the changes, click Cancel.

Using Client Bridge Mode

Wireless 2.4GHz or Wireless 5GHz >
1
Log into your access point management page (refer to
on page 10).
2
In Wireless 2.4GHz or Wireless 5GHz > Wireless Network > SSID section, specify the
static SSID manually or click Wireless 2.4GHz or Wireless 5GHz > Wireless Network >
Site Survey.
3
The available networks are listed. Select a network to connect to.
If you are unable to find your wireless network in the list, click Refresh to rescan
ÍNote:
for the available networks.
4
Click on the SSID field to connect to the selected wireless network.
5
Click Apply to save the wireless network.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Log in to Management Page"
Wireless Network
"Log in to Management Page"

Repeater Mode

When Repeater Mode is selected, the selected wireless interface functions as a wireless
repeater and is able to repeat the wireless signal of an access point. This feature is used
to expand your existing wireless network on places your current access point is unable
to reach. Make sure all the settings on selected interface of the TEW-821DAP matches
the wireless access points you want to repeat in same wireless settings including SSID,
channel and wireless encryption settings.
Repeater
TEW-821DAP
2.4GHz 5GHz LAN PWR
22