Ipv6 Settings - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide

IPv6 Settings

System > IPv6 Settings
Use this section if you are connecting this device to an IPv6 network and require this
device to use IPv6 addressing. IPv6 is a updated IP addressing protocol which offers
advanced capabilities and improvements over the more commonly used IP address
standard (IPv4).
1
Log into your access point management page (refer to
on page 10).
2 Click System > IPv6 Settings.
3
Select the mode to be used by the access point to connect to an IPv6 network.
• Link-Local Only: The link-local address is used to communicate to neighboring IPv6
capable network devices that are connected to the same network segment. This is
similar to the function automatic network IP addressing (APIPA) if a device cannot
pull IPv4 address settings automatically from a network DHCP server.
• Static IPv6: Use this option to manually configure the IPv6 address settings of the
device for connectivity to your IPv6 network.
Configure the following settings:
© Copyright 2015 TRENDnet. All Rights Reserved.
"Log in to Management Page"
ƒ LAN IPv6 Address: Enter the static IPv6 address to assign to your device (i.e.
1234:5678:90ab:cdef::a or 1234:5678:90ab:cdef:0000:0000:0000:000a).
ƒ Subnet Prefix Length: Enter the IPv6 subnet prefix length(1-128, 64 is typically
the standard prefix).
ƒ Default Gateway: Enter the IPv6 default gateway address (i.e.
1234:5678:90ab:cdef::1 or 1234:5678:90ab:cdef:0000:0000:0000:0001).
ƒ Primary DNS Server: Enter the primary IPv6 DNS server address (i.e.
1234:5678:90ab:cdef::1 or 1234:5678:90ab:cdef:0000:0000:0000:0001,
2001:4860:4860::8888 2001:4860:4860::8844).
ƒ Secondary DNS Server: Enter the secondary IPv6 DNS server address (i.e.
1234:5678:90ab:cdef::1 or 1234:5678:90ab:cdef:0000:0000:0000:0001,
2001:4860:4860::8888 2001:4860:4860::8844).
• Autoconfiguration (SLAAC)/DHCPv6): Use this option to configure the device to
obtain IPv6 address settings automatically from a DHCPv6 server on your network.
Configure the following settings:
ƒ Obtain IPv6 DNS server address automatically: Select this option to configure
the device to obtain the IPv6 DNS server addresses automatically from the
DHCPv6 server on your network.
ƒ Use the following IPv6 DNS Servers: Select this option to manually configure
which IPv6 DNS server addresses the device will use.
4
Click Apply to save changes or Cancel to discard the changes.
TEW-821DAP
32